Updates and Stuff: Quadlock Charger Stand, Mechanical Egg V2, 26mm Tube Box (Patreon)

A few updates and random models!

Mechanical Easter Egg - larger tolerances

We're a little past Easter now, but there's always time for mechanical eggs!  Some people found the gearing a bit tight on the original model, so a second version is up in the same folder, and it has more generous tolerances for easier printing.

You'll find it at at 590 Mechanical Easter Egg

Link to dropbox post: https://www.patreon.com/posts/31697592

Quadlock Phone Charger Stand

This is a phone stand intended specifically for the Quadlock MAG wireless charging head, which in turn is for phones equipped with Quadlock cases.  If you happen to use such a phone case and the wireless charging head is compatible with your phone, then this is the phone stand for you!

The model is hinged for portability and printability, and sits at 30 degrees to vertical when in use.  The charging head bolts into the mount and a channel is provided to route the USB cable into the head once it's in place.  Note that Quadlock don't provide an actual nut in the charging head kit - you'll need to source an M5 hex nut.

Since this is a fairly long, narrow print, you might want to print it at 45-degree angle, in which case it'll fit in a 208mm square.

You'll find this one at at 585 Quadlock Charger  Stand

Link to dropbox post: https://www.patreon.com/posts/31697592

26mm Rectangular Tube Box

There's a new size in Rectangular Tube Boxes - a square with a 26mm square interior.  It's wider than the existing models, but the closure cap remains the same as previously. 

You'll find this one at at 622 Rectangular Tube Boxes

Link to dropbox post: https://www.patreon.com/posts/31697592