Original Ultra Ball Now Available! (Patreon)

Hey everyone, 

I've finished testing the Original Ultra Ball and it is now available in the archives!  As with all the other pieces and variations to this design, it all snaps together with no glue required.  

Just like with the Heavy, Master, and Great Balls, this design uses all the same pieces as the Original Pokeball.  You only print the Ultra Ball Top Shell in black (or dark grey) instead of the standard red one, and then the additional yellow accent pieces (3 pieces).

Here is a link to the files if you would like to print it:
https://drive.google.com/drive/folders/15XHUdvSkU-Eosz_AL4gIeeg0S6yw4SO_?usp=sharing  

One tip for getting easier snaps if its a little tight; try adjusting Horizontal Expansion (Cura) or XY Compensation (PrusaSlicer) to -.05mm to - 0.1mm.  What this setting does is opens up the gaps by the value you set it to.  The negative value opens up gaps (makes things 'looser'), if you use a positive value it closes up gaps (makes things tighter).

I've tested these on a few different printers and have it to the level where the snaps are tight enough to not come apart, but fairly tight to snap together so I welcome any and all feedback!

As always, thank you all very much for the support!

- Jacob