'Reimagined' Firehouse Playset - PART 2 - Garage Walls (Patreon)

Another set of Firehouse files are ready - this set is for building out the walls of the Ecto garage with the iconic archway. The archway - when fully opened - was designed to provide enough clearance for the Kenner Ectomobile to fit through with the gunner seat and a figure! In fact, you might say this entire 3D printing exercise stems from this single childhood frustration that has been simmering for over 30 years.....

(Note: if you are just starting, get Part 1 files here...)

I printed the firehouse walls using a "Matte Marble' PLA by PolyMaker. It prints VERY clearly and gives off a light-grey stone look. I'm sure it'd look even more realistic if you put a dark wash and weathered it up a bit. Right now, mine is sitting pristine and clean.

Here is my print of these files...