The Pumpkin'O'lorian updates (Patreon)

Ok i finally made the required updates to the pumpkinlorian :D 

before i talk about the project updates just a few words about the mesh - the interior might be a bit "lower poly" then we are used to but thats due to the fact that i didnt design it for all the changes, so i had to improve, however good news is that interiors is not really importannt, and ofc its still not terrible, so we're good to go. 

Another thing that might pop up is if you toss it into meshmixer - it might show some "errors" on some smaller points - you can ignore that, gcode generates without a problem, those erros usually appear when you have (once again) a high poly mesh and try to do with it what initially wasnt planned :D 

But long story short - all is good, you can print without problems :) 

so whats included ? 

1- Helmet option - it is scaled up- i added a thickness of 5 mm due to all the details so i was a bit worried it would be too fragile otherwise. There is also an "cut" option in 6 pieces, unfortenatelly since i handsculpted evrything in at the start of the design its impossible to seperate the ears and the back vent :/ sorry :/ 

Any other slice opttion can be performed with a regular "plane cut" in meshmixer or in prusa slicer

2. candy bowl option - i made a lid that can be prined flat on the bed so you can use it to cover up the "candy bowl". I also did an option with eyes cut out for the candy bowl in case you wish to use lights instead with that method.

3. Lights insert option - once again 2 options - with and without the vizor/eyes, and the lid on the bottom is removeable and you can twist it to "lock" in place, well pretty much "hold" in place - reason i didnt want to make a tight fit lock isin case something goes wrong in there with light/candles etc., so you can quickly grab it and just toss out.

Well, this is it, im gonna go and print a few of these, you can try using the combos in various ways, and im looking forward to seing some photos :)