Home Artists Posts Import Register

Content

Hey everyone!

Time for this month's exclusive magnet/keychain set :) The chameleon set!

Print instructions:

  • 2-3 walls
  • 15-20% infill
  • No supports
  • Photos here are done with 0.2 layer height, for higher detail you can print at 0.1 layer height* Magnet is made for magnets with 1 inch diameter and about 4.5-5mm thickness. I secured mine in with a small dab of superglue and they're golden! I went with the glue-in magnets vs print inside magnets because I wanted to ensure the magnets would be as strong as possible, and any layers of filament between the magnet and surface it's on would weaken that strength.

He'll be in this month's file releases and ALSO will be in the Patreon Exclusives set permanently.

Model link: https://www.kekreationsart.com/patreonmod

Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

Hope y'all enjoy this one!

Thanks so much for all your support <3

- Kek

Files

Comments

No comments found for this post.