Hanging Dragon Planter EARLY ACCESS (Patreon)

Hey everyone.

Everybody really enjoyed the planter released a couple of months ago, so here's a new one! The hanging dragon planter. Works with twine, rope, or chain (2 strings/chains through the mouth, connected down to 4 hooks on either side of the planter. Really happy with how this baby turned out, and hoping y'all like it, too!

Print rec: 

* 2-3 walls

* 10-20% infill

* No supports on head. Support under the very tip of the egg is optional, but me and Kyyrbes don't think it really needs them since it manages the bridging and even if it's not super pretty, the bottom inside of the planter will never be seen.

* If you want to add supports, it really only needs it about an inch diameter support in the very top middle section.

Model link: https://www.kekreationsart.com/patreonmod

Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

Thanks so much for all your support! <3

- Kek