Flexi Leopard/Panther + Baby Keychain EARLY ACCESS (Patreon)

Hey everyone!

I'm suuuuper excited about this month's community suggestions winner release! The flexi leopard, along with baby leopard of course! I'm sooooo happy with how these guys turned out, I love them! As you can see, I gave the leg joints on the adult a total re-design! This gives them more fluid movement, easier possibility, a more sleek look (in my opinion) AND easier printability since the shoulder and hip sections wrap around the outside of the leg joints, helping give a lot better support to keep the head from wiggling and losing adhesion as it prints up.

I will most likely be going back in slowly over older flexi models to add these new leg joints as well to cut down on print failures for y'all :).

And of course we got the baby leopard as well, same as the other babies! <3 Options with and without keychain holes in the tail.

Bambu multicolor 3MF files included.

Print recs:
2-3 walls
10-15% infill
Add a brim if you have adhesion issues
Both adult and baby tested down to 65% size fine
The feet on the adult somewhat 'lock' into place when tilting them to stand and sit and such, so it's expected for them to be tighter at those angles.

Model link: https://www.kekreationsart.com/patreonmod

Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

I hope y'all love them!

Thanks so much for all your support <3

- Kek