Box for Lever Nuts Wire Connectors (Patreon)
Downloads
Content
This was a request, I don't have those in hand, they seem very handy as an interface between the printer board and the printer
This also could be use to cram in regular connector and hide the mess, there are 10 opening on top/bottom
box is meant to be secured with M3 t-nuts and m3 screws
For this type of connectors
40mm long
9 wide
15mm tall
When clipped together they have a pitch of 8.5mm
This printed box will fit 10 of them
it's a very simple box, connector would not stay in place on their own vertically. but that mean its easier to remove and put back ;)
If there is interest for it to stay in place, let me know and I'll buy some to perfect it.
Uses four 6mmØx3mm (or 2.5mm) round magnets to close to lid,
Has an optional model with an PC4-M10 (M10 pneumatic coupler as found on top of the creality stock hotend) with in mind to be used as a reverse Bowden.