Gonk Droid Trash Can (updated 1:6 Scale Added) (Patreon)
Downloads
Content
Hiya,
Edit - P14 was bugged, have uploaded just a plain flat topper for the rear rube
Have added the 1:6 scale (no hinge) (based off of the standard size of a 1:1 Gonk being approx 114cm high (45") high, therefore a 1:4 = 28.5cm high, 1:6 = 19.0cm high - so the 1:6 scale stands (not including antenna) at 190mm tall when assembled. It is in a simpler print and the base has been flattened more for a better print (total of 7 parts)
This shouldn't be too hard to print, not really many instructions needed - other than please try a small one first! at least until someones tested the hinge.
No assembly instructions really required with this one, just print and assembly the bottom half with the feet, then the top half then slide the 2 pins through the hinge (which has plenty of tolerance)
Will add also a variation that has no hinge at all and is a simple box lid tomorrow,
enjoy!