GOT - The Hound Helmet (Patreon)

An intermediate helmet to build, it has a few parts (have uploaded uncut also) I didin't smooth it out too much, I sort of left it looking like battered steel, more flat edges rather than sharp etc, it should print out pretty clean.

It is scaled for a normal head - if you want to go full on massive scale like it is in the show you will need to scale this up a fair bit - but as it is the neck piece and dome (even without the face attached) is 42cm long (tall) and 34cm wide, head section is around 19cm wide inside the dome - so this is pretty big as it is but feel free to scale it up.

I added an optional 6 part face also as Face part 1 and 2 will not fit on an ender bed.

Suggest printing The face pieces first to see how large this thing actually is!

The hinges for the jaw and face are pretty simple, the face has a small bendable clip that bends slightly and finds the next locator hole to stop the face sliding down. Its a pretty simple assembly. I hope it is strong enough to hole the face in the upward position, if not increase the scale of the face bolt clip (the ring thing...) slightly, this will increase the tolerance in the face lock positions.

The jaw also has two small divets and a nodule that sits in them so when you pull the jaw down, it stays in the lower position.

Assembly pics inside the zip..
----

EDIT

I realised the assembly main picture was wrong with the part numbers, please look at the updated_assembly below and download the 2 extra pieces that are part of the neck I forgot to put in the zip (they are small thin pieces, you could almost not print them as they are inside the mask but they provide some extra space filler under the chin.

Enjoy :)