Ok.. now it's done... (Patreon)
Content
The small buckles (the 4 that go around the head) are separate too of course and not in the image above, I left the cavity empty to make molding and casting easier also. Doing the buckles by themselves is a no brainer really.
The hex pattern section is actually separate and prints separate (see attached photo down below...) I understand this may be tricky on some printers and you don't want to print a whole helmet out and have that one section not print well.. so I decided to make this separate, it may also significantly help those wanting to make a cast out of their helmets.
Also, never be afraid to ask for any modifications! - if I don't answer a message it just means I haven't read it yet. I am not joking, it takes me less time to make a 3d model than it does to go through all my inboxes and emails each day.. If there was one thing I would say that is currently the most difficult part of my days is getting back to everyone. If I was on any more platforms than CG Trader cults or MMF.. or thingy.. or patreon... or facebook.. (gah ) and I don't even Tweet!... Honestly without an assistant I don't know how some people keep up with it all and manage to get any work done lol...
ah well that's a good job for the kids when they are old enough! :)
Dropbox links are now inactive (I have set a time limit on them now as we were having non patreons access old folders due to some non expiring links...) so they are valid for 7 days after they are posted, this is something I should have divulged yes, for that I apologize to anyone who cant find files at the moment.
If you are a new patreon and you need access to the files, just send me a message. I'll be on for the next 15 hours or so so any messages should get a pretty fast reply.
PrintWeek Issue #7
(jeez I could call it Printmonth at the rate Im going after this xmas break.. sorry )
It is going to be a BUMPER issue, for all levels. Lot's of extras to celebrate the new year, it will be the biggest issue as far as how much is in it that I have done yet, probably over-did it a little but I don't think anyone will complain :)
Back to the grind I go, pushing for issue release tomorrow, still have a few things I want to finish off/double check.
cheers
G.