CTR 2.0 RC3 RELEASED! (Patreon)

Changelog:

* "TEMP.ini not found or file corrupted" completely fixed. The temporary values are saved in two files.

* Improved support for low write speed SDDs or "dirty" OS. Avoids situations where logs or settings were corrupted due to a computer reboot.

* "LibreHardwareMonitorLib" is removed from CTR. The monitoring response speed has increased up to 3 times. Response time during idle time is about 600µs, during 100% load it is 2000µs.

* The limit for the maximum voltage is now 1.45V. A warning has been implemented if the user is using voltages over 1.35V.

* Improved stability of sending a command to SMU.

* Information about the SMU version will be available in google-statistics. 

* HYBRID OC now cannot be enabled during tuning or diagnostics.

* Found and fixed bug of AVX instruction execution in Zen3 processors (FFT 4096 changed to 2048). This sometimes caused sharp PPT jump, computer reboot or false error in CHECK STABILITY mode. Perhaps this problem also applies to Zen 2. I'll check it out.

* Information about "CCX VID injection" is also available in diagnostic mode.

* "CCX VID injection" information will be displayed if the value is greater than 0.

* "CCX VID injection" on some processors with 1 CCX was 0. Partially fixed. However, there are many situations where the motherboard manufacturer has blocked this feature. Hopefully I will get a complete solution to the problem in CTR 2.1.

* Added some tooltips.

* Fixed rare bug when VID was stuck at 1.1V. Sometimes it could cause reboot while HYBRID OC was running.

* Redesigned LLC recommendations. The recommended ranges have been changed.

* Added information in diagnostic mode for "CCX delta".

* Changed frequency for diagnostics (only for Zen 3). Correspondingly, the ranks of processors have changed slightly.