EXCLUSIVE - 3D Printed Slime Blower Mark 2 Files and Instructions (Patreon)

The 3D printed Slime Blower Mark 2 is a set of upgrade modules designed to attach to a "full size" Neutrona Wand. My goal was to minimize the modifications needed to the base wand prop although you may need to be agile depending on what your base thrower is.

Click here to visit the 3D build dashboard! (WebGL 2.0 brower required - Chrome or Firefox)

Here are few key notes:

• The slime gun box module is designed to fit over the right side of the original gun box - including the heat sink. 
• The included gun track is meant to tie into the original thrower gun track using 3 holes. Depending on your thrower, you may need to adjust these holes before or after printing.
• A small bracket is design to connect the gun boxes together under where the Clippard valve is mounted.

What may make this a challenging build is that dimensions of the "base" thrower you may own may not perfectly align with these parts. Builders should expect that they'll need to make small mods to the parts before or after printing to get them to fit your thrower. My own build has these parts attached to an Anovos kit I procured on eBay a few years back which seems to also closely share dimensions with my "Throwing Chicken" kit.

In any event, give these parts a try - what brand of base throwers are you folks using? I am considering getting a hold of a Hasbro Spengler Wand and adjusting the parts to fit since that seems to be in wide use these days.