Hex Headphone Hooks (Patreon)

Howdy, wonderful people!

Modern, thin monitors can be a convenient place to hang your headphones!  This little hook hangs over the front of the monitor just a little so as not to obscure the display on small-bezel setups, and provides a curved platform at the back on which to hang ones trusty headset.

Since the depth of the monitor needs to be just a little smaller than the hook width there are a few different sized hooks provided.  The profile of the front also needs to be fairly square, and not too rounded.  I've had these on a few monitors, but also found one or two that just didn't play nicely with this approach (and then I fall back to the clamp filament spool holder!)

This is a single-piece print, but obviously I like swapping filaments and making stripes, especially when someone asks for a print, and says "just use any colour" :)

Print Description

This is a regular mode print that is pretty much all perimeter and no infill.  It prints on its side, so you might consider a brim if you're at all concerned about your bed adhesion!

There are two versions - one with hexagons, and one without, just in case all the retraction is problematic.

Print Dimensions

The smallest hook is 25mm x 52mm on the print bed and is 71mm tall.

Supports Needed?

Not at all!  Designed for straightforward printing!

Scalability

There's no technical reason this can't be scaled if that suits your purposes somehow!

Print Orientation

The hooks print on their sides, like so:

File Location

You'll find this one at at 615 Hex Headphone Hook

Link to dropbox post: https://www.patreon.com/posts/31697592

Further Thoughts

This is one of those models I use every day and hadn't thought about posting until someone in the Clockspring3D discord asked if there was a headphone holder that wasn't a huge multi-day print :)

Happy printing!

xoxo

Sven.