Monster Manual Revisited: The Banshee! (Patreon)

Slowly but surely I'm revisiting my old models! Its been a satisfying experience so far. The original Banshee I made still isn't bad though so if you need a more FDM friendly version you can always use that. But this one should work just fine as well. Just tilt it on its back and use supports and a raft. For resin tilt it backwards about 20 degrees or until the fingers no longer need thin supports. 

Full files are in both drives under B - Banshee. You can find them here too:  https://www.prusaprinters.org/prints/27317-banshee-updated  

Next up is one I'm pretty excited about: the Basilisk! I'm going to go all out on that fella. He's a personal favorite of mine :-)