Cat Keychain/Magnet Set PATREON EXCLUSIVE (Patreon)

Hey everyone,

Time for this month's magnet/keychain set! Finally the kitty head for this set :) 

Print instructions:

• 2-3 walls
• 15-20% infill
• No supports
• Photos here are done with 0.2 layer height, for higher detail you can print at 0.1 layer height* Magnet is made for magnets with 1 inch diameter and about 4.5-5mm thickness. I secured mine in with a small dab of superglue and they're golden! I went with the glue-in magnets vs print inside magnets because I wanted to ensure the magnets would be as strong as possible, and any layers of filament between the magnet and surface it's on would weaken that strength.

Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512

Hope y'all enjoy this one!

Thank you so much for all your support and for the feedback and encouragement on the recent Patreon changes! <3

- Kek