Wraith: Test Prints (Patreon)

Printed on Ender3 and sliced with Ultimaker Cura 4. 

The layer height for these test prints were set to 0.15 mm with wall line count at 2. One of the sockets broke off because it was so thin, so on the final print I would set the wall count to 4 or higher. Every socket fits really snug at this size and thickness, so the final character print size will be larger and finer. I might make room in the socket holes for adhesives though. Each of these pieces took 40 minutes to 3 hours to print, and I expect my final prints to be 10 hours + per piece to get the best quality I can from a PLA printer.

I did not print the base because of how huge I realize it was and took A LOT longer than I expected, so I went back into zbrush and resized it to be more eco friendly.